Siemens T1000, Administration Manual

Page: 59 / 88

Chapter 2 Managing RAS Features and System Firmware 37
Displaying System Fault Information
ALOM CMT software enables you to display current valid system faults. The
showfaults
command displays the fault ID, the faulted FRU device, and the fault
message to standard output. The
showfaults
command also displays POST results.
▼ To Display System Fault Information
●
Type
showfaults
For example:
Adding the
–v
option displays additional information,
For more information about the
showfaults
command, refer to the Advanced Lights
Out Management (ALOM) CMT v1.3 Guide .
Multipathing Software
Multipathing software enables you to define and control redundant physical paths
to I/O devices, such as storage devices and network interfaces. If the active path to
a device becomes unavailable, the software can automatically switch to an alternate
path to maintain availability. This capability is known as
automatic failover . To take
advantage of multipathing capabilities, you must configure the server with
redundant hardware, such as redundant network interfaces or two host bus adapters
connected to the same dual-ported storage array.
For your server, three different types of multipathing software are available:
sc> showfaults
ID FRU Fault
0 FT0.F2 SYS_FAN at FT0.F2 has FAILED.
sc> showfaults -v
ID Time FRU Fault
0 MAY 20 10:47:32 FT0.F2 SYS_FAN at FT0.F2 has FAILED.