NLSoftening System
10.2 Set water softening
The rinse aid container can be
corroded by dishwasher softening salt.
▶
To ensure that spilled softening salt
is rinsed from the rinse aid
container, the softening salt must
be filled into the softening salt
reservoir immediately before the
program starts.
Set the device to the water hardness.
1.
Determine the water hardness and the
desired setting value.
2.
Press.
3.
Approx. 3 seconds on
to access the basic settings.
pressure-
1.
Open the lid of the softening salt
reservoir and remove it.
aThe display shows Hxx. aThe
display shows
to give.
4.
Just as often on
the desired water hardness is set.
2.
When using for the first time: fill the
reservoir completely with water.
reflected
3. Note:Only use softening salt for
dishwashers.
Do not use salt tablets. Do not
use table salt.
press to
The factory setting is H04.
5.
To save the settings, press . for
about 3 seconds
to press.
Place the softening salt in the
softening salt reservoir.
10.3 Softening salt
You can soften the water with
softening salt.
Filling softening salt
If the Refill softener salt indicator
lights up, top up the softener salt in
the softener salt reservoir immediately
before the program starts. The
consumption of softening salt
depends on the degree of water
hardness. The higher the water
hardness level, the higher the
consumption of softening salt.
Fill the water softening salt
reservoir completely with softening
salt. The water in the reservoir is
displaced and flows away.
4.
Fit and close the lid of the
reservoir.
PAY ATTENTION!
Dishwasher detergent can damage the
water softener.
▶
The water softener reservoir
with depilatory
filling washers.
10.4 Switching off water
softening
provision only
ding salt for dishes
If the refilling salt indicator bothers
you, e.g. if you use a combined
dishwasher detergent with
26
