Commissioning
7.6 Telescoper adjustment
SITRANS WW300
22
Operating Instructions, 05/2015, A5E33560691-AB
7.6
Telescoper adjustment
1.
Determine which side of the weighfeeder you want to adjust. Compressing the telescoper on
one side will cause the belt to drift toward that side of the weighfeeder. Conversely, extending
the telescoper will cause the belt to drift away from that side of the weighfeeder.
2.
Loosen the jam nut.
3.
Turn the adjusting screw in the desired direction. Often, only a small amount of adjustment (1
turn or less) will be required.
4.
Observe the results of the adjustment and then readjust, if necessary.
Steps 2 and 3 may need to be repeated to obtain perfect belt tracking.
Note
As you extend or compress the telescoper, you may be changing the belt tension. If belt
tension has increased (or decreased) considerably while attempting to track the belt, then
compress (or extend) both telescopers and complete the belt tracking process again. To
avoid this problem, extend one telescoper while compressing the other to obtain proper
belt tracking.
5.
Re-tighten the jam nut located on the telescoper to maintain the new telescoper position after
completing the tracking procedure.
6.
If you are having problems tracking the belt, consult your Siemens representative. Common
causes of belt tracking problems are: uneven or improperly distributed product loading,
twisted frame, or product buildup on head or tail pulleys.
①
Adjusting screw
②
Jam nut
③
Driven shaft
Summary of Contents for SITRANS WW300
