Commissioning
7.5 Autom. initialization
SITRANS VP300 with or without HART
136
Operating Instructions, 03/2011, A5E01258666-03
7.5
Autom. initialization
Requirement
You have prepared the positioner for commissioning, as described in section "Preparing for
Procedure
In order to initialize the positioner automatically, proceed as follow:
1.
To change from the measurement view into the navigation view, press . You are in the
"1 Quick Start" main menu.
2.
Click four times. The display shows the following:
3.
Select the actuator type with or
4.
Confirm the selection with . The set actuator type is displayed.
The factory setting is "Linear <= 60 mm".
5.
If required, set the tight closing function.
Use or to switch to the menu "1 Quick Start > 1.1 Autom. initialization > 1.1.2 Tight
closing > Edit".
