Siemens sitrans tr200, Operating Instructions Manual

Page: 50 / 78

Functions
8.16 Factory parameters
SITRANS TR200/TR300
50
Operating Instructions, 04/2007, A5E01071992-01
8.16 Factory parameters
The menu item Device ➜ Factory parameters ➜ Reload factory settings resets the
configuration of the transmitter to its default values.
Note
Factory Reset
•
The menu item Device ➜ Factory parameters ➜ Reload factory settings resets the
configuration of the transmitter to the default values in the table below.
•
This Factory Reset has the same effect on "ex stock devices" as it has on "customer-
specific configured devices".
•
Furthermore, resetting the transmitter to its default values also resets any customer-
specific digital-to-analog trim and sensor calibration (one point trim or two point trim).
Once a factory reset has been performed, the transmitter has the following configuration:
Parameters Reset to value
TAG Are not reset.
Description Are not reset.
Message Are not reset.
Serial number Are not reset.
Installation date (electronics) Are not reset.
Sensor class Resistance thermometer
Sensor type Pt100 DIN IEC 751
Interface Normal connection
Sensor connection Three-wire input
Sensor factor 1.00
Sensor offset 1 0.00 °C
Zero point 0 °C
End of measurement 100 °C
Unit °C
Broken wire monitoring ON
Short-circuit monitoring OFF
Short circuit limit 1.00 Ω
Lower end point analog output Are not reset.
Upper end point analog output Are not reset.
Alarm value Are not reset.
Linearization type Linear to temperature
Damping 0.00 s
Operating hours counters PV Are all reset to 0 h.
Operating hours counters, field device Are not reset.
Slave pointers PV Are all reset to 0.
Slave pointers electronics temperature Are not reset.
Manufacturer data sensor Are not reset.