(1) Process values
This area shows the real process values (
PV1
,
PV2
,
PV3
and Bypass values) along with their
units.
(2) Enabled operations
This area shows all operations for which special operator authorizations are assigned. They
depend on the configuration in the engineering system (ES) that applies to this block.
Symbols for enabled operations:
● Green check mark: The OS operator can control this parameter
● Gray check mark: the OS operator cannot control this parameter at this time due to the
process
● Red cross: The OS operator cannot control this parameter due to the configured AS
operator permissions (
OS_Perm
or
OS1Perm
or
OS2Perm
)
The following enabled operationss are shown here:
General enabled operationss:
● "Reset": You can reset the peak value of the gradient.
● "On": You can switch to "On" mode.
● "Out of service": You can switch to "Out of service" mode.
● "Local operator authorization": Use the button ← to change to the standard view of
the
OpStations
block. For more information, refer to the "Operator authorizations" section
in the APL Online Help.
(3) Button for switching to the standard view of any faceplate
Use this navigation button to open the standard view of a block configured in the engineering
system. The visibility of this navigation button depends on the configuration in the engineering
system (ES).
You can find more information on this in the section "Opening additional faceplates" in the APL
Online Help.
16.1.9.6
Totalizer view of Mr200
Figure 16-4
Totalizer view of Mr200
MultiRanger 200
16.1 MR200
SITRANS Library for PCS 7
Function Manual, 05/2019, A5E35351976-11
765
Summary of Contents for SITRANS PCS 7
Page 12: ...Table of contents SITRANS Library for PCS 7 12 Function Manual 05 2019 A5E35351976 11 ...
Page 418: ...SITRANS P 10 2 SitraPDr SITRANS Library for PCS 7 418 Function Manual 05 2019 A5E35351976 11 ...
Page 850: ...Index SITRANS Library for PCS 7 850 Function Manual 05 2019 A5E35351976 11 ...