Operate
6.2 Parameter description
SITRANS P500 with HART
124
Operating Instructions, 12/2014, A5E02344528-09
Menu entry
Designation
Adjusta-
ble
Pre-set Factory setting
•
3.2.6.10
–
3.2.6.10.1
–
3.2.6.10.2
–
3.2.6.10.3
–
3.2.6.10.4
–
3.2.6.10.5
–
3.2.6.10.6
–
3.2.6.10.7
Sensor
Sensor Serial No
Sensor Order Number
Module Range Code
Lower Range Limit
Upper Range Limit
Minimal Span
Firmware SENSOR
-
-
-
-
-
-
-
X
X
X
X
X
X
X
in accordance with the measuring cell selection/
device manufacture
e.g. 7MF5944-1DA1
1)
e.g. -250...250 mbar
1)
e.g. -250 mbar
2)3)
e.g. 250 mbar
2)3)
e.g. 1.25 mbar at 250 mbar
2)
in accordance with the measuring cell selection/
device manufacture
3.2.7
Firmware Device
-
X
in accordance with the measuring cell selection/
device manufacture
3.2.8
Hardware Device
-
X
in accordance with the measuring cell selection/
device manufacture
1)
in accordance with the order
2)
in accordance with the measuring cell selection/ device manufacture
3)
Max. +10 % depending on the installation position, sensor trim
6.2.4.3
"3.3 Process Variables"
"3.3.1 Current Out"
Display:
3,55 ... 23 mA
Purpose:
Displays the output current
Description:
This parameter shows the current digital value of the output current. For
deviations from the analog output current, use the function "2.4.3.1 DA-
Converter" (Page 106).
"3.3.2 ... 3.3.10 User"
The menus show the measured value in the unit you selected.
Menu entry
Designation
3.3.2
PV Percent Range
3.3.3
Pressure
•
3.3.3.1
•
3.3.3.2
•
3.3.3.3
Untrimmed Pressure
Static Pressure
Pressure
3.3.4
Temperature
•
3.3.4.1
•
3.3.4.2
Sensor Temperature
Electronic Temperature
Summary of Contents for SITRANS P500
Page 1: ......
Page 2: ......
Page 10: ...Table of contents SITRANS P500 with HART 10 Operating Instructions 12 2014 A5E02344528 09 ...
Page 238: ......