Siemens SITRANS FUH1010, Product Instruction Manual, Page: 51 / 264

Connecting
5.6 Sensor Installation
FUH1010 IP65 NEMA 4X Precision Volume
50
Operating Instructions, 01/2013, A5E32122003-AA
5.6 Sensor Installation
5.6.1 Preliminary Installation Procedures
Reflect and Direct Sensor Mounting
Reflect and Direct mounting modes are supported for clamp-on sensors. The transmitter
recommends a mounting mode after analyzing your pipe and liquid data entries.
1.
After receiving the spacing index from the Installation Menu, prepare the pipe surface
area where the sensors will be mounted. Use the supplied abrasive material to prepare a
clean contact surface for the sensors.
2. Make a note of the Number Index displayed in the [Install Sensor] menu. Check to ensure
that you have a matched set of sensors. They both should have the same S/N number
but marked with either an "A" or "B" (e.g. 100A and 100B).
Mounting Supplies
The following items will be needed to mount the sensors in addition to what is supplied:
●
Flat blade screwdriver
● Tape, chalk and a ruler or measuring tape (For Direct mounting)
Mounting Strap Kits
The available Mounting Strap kits are listed below. Each kit comes with bands. Sizes cover
designated pipe diameter ranges and a spacing guide for Direct Mount.
Mounting Strap Kits Pipe Diameter SAE Band Sizes (Qty.)
7ME396000SM00 50.8mm (2-inch) to 177.8mm (7-inch) #88 (2) #128 (2)
7ME396000SM10 50.8mm (2-inch) to 330.2mm (13-inch) #88 (2) #152 (2)
7ME396000SM20 330.2mm (13-inch) to 609.6mm (24-
inch)
#188 (2) #280 (2)
7ME396000SM30 609.6mm (24-inch) to 1219.2mm (48-
inch)
#152 (4) #312 (4)
Note
Optional lager bands sizes are available for larger pipe diameters.