Siemens SITRANS F TRANSMAG 2, Operating Instructions Manual, Page: 42 / 126

Operation via local display
The device is operated with the optical elements on the local display.
The elements are actuated by touching the glass panel above the appropriate operating
element. The text display above the operating elements gives a menu-guided operation of the
individual device functions/parameters.
/&'
2SWLFDOLQIDUHGNH\SDG
,QIUDUHGWUDQVPLWWHU
Figure 6-1 Local display of the SITRANS F M TRANSMAG 2
Note
Operation does not require opening of the device. This means that the high degree of protection
of IP67 is guaranteed at all times.
Navigating the menu structure
The available device functions and parameters are shown in the second line of the display. You
can select them there with the and operating elements. You can scroll in the selected
device function or setting level of the parameters (Enter function) with . It is possible to exit
the selected function or setting level to the level above with .
The currently valid setting appears after selecting the setting level of a parameter. The
programmable value flashes in the second line of the display when programming is enabled. You
can change the parameter setting in this position. You have to decide between the following
types of input to enter data:
• Direct numeric input
• Input from given table
In the numerical input, the and operating elements have the function of a cursor control.
The selected digit flashes. You can now set the desired digit or move the point to the right or left
with the and operating elements. Digits are input with carry over to the next highest place.
After selecting the last digit you terminate the input by pressing the operating element. The
entered value is accepted if it is within the permissible input range. In this case, the user
guidance returns to the selection menu for the parameters of the group concerned. If the
Commissioning
6.1 Operating TRANSMAG 2
TRANSMAG 2 with MAG 911/E
42
Operating Instructions, 03/2021, A5E00102775-AC