Operation
6.2 Digital display
SITRANS DA400 for material flow monitoring with protection against explosion
Operating Instructions, 09/2007, A5E00841152-01
37
6.2
Digital display
Introduction
The sections below give an overview of the elements that appear in the digital display.
Layout
Pressing the <MEAS> button in the measuring menu activates a test of the digital display,
see the following figure:
Figure 6-2
Digital display
➀
Upper section
②
Middle section
③
Lower section
Description
In the upper section ➀ of the digital display, alarm messages are indicated using symbols:
●
Pre-alarm
●
Main alarm
●
Summation alarm
In the middle section ②, the digital display shows the following, depending on the selected
menu:
●
Measured value or fault symbol, parameter value, timer value (trace)
●
Channel number, parameter name, timer name (trace)
In the lower section ③, the digital display shows the following, depending on the selected
menu:
●
PAR in parameter menu only
●
Value for main alarm or limit value, parameter number, time unit in trace menu.
