3SU14 modules
8.2 Mounting
SIRIUS ACT 3SU1 pushbuttons and signaling devices
200
System Manual, 08/2018, A5E03457306020A/RS-AK/010
5.
Snap the contact module(s) from behind onto the holder.
To do this, hold the modules so that they are tilted downward slightly and place them onto
the holder from behind (snap the narrow snap hook (b) into the appropriate contour on
the holder) and then press them upwards until you feel the broad wide snap hook (a)
latch in the holder.
Single- or two-pole contact modules can be mounted on the holder. (Only 1-pole contact
modules with enclosure mounting)
6.
Ensure secure latching.
7.
Connect the cables to the modules. You can find the relevant information in Chapter
a
Broad snap hook
b
Narrow snap hook
Typical diagram
8.2.1.2
AS-Interface modules, electronic modules for ID key-operated switch / IO-Link
You can find information about installing ASi modules in the section AS-Interface in Chapter
"Mounting (Page 261)".
You can find information about installing electronic modules for ID keys in the section IO-Link
in Chapter "Mounting (Page 338)".
You can find information about installing electronic modules for IO-Link in the section IO-Link