Installation of TFT displays
2 - 7
Siemens AG
SPR2-230.812.02
Page 7 of 8
SIREMOBIL
Medical Solutions
Rev. 02
02.06
CS PS SP
System Manual
Wiring of the displays
2
•
Open the rear panel of both TFT displays above the connections.
•
Route the power line cables and the video cables to the TFT displays.
BARCO displays
2
•
Connect the video cable to the BNC sockets VIDEO of the displays and lock it.
•
Connect the shieldings of the video cables to the ground of the display.
•
Plug in the power cables.
•
Close both covers again located above the display connections.
Running the cables
2
•
If required, retract the power line cables and video cables into the monitor trolley.
- Route the cables without sharp bending radius.
- It is recommended to ensure that the cables are covered by both support arm rails in
the area between support arm base and the displays (see Fig. 11).
- The cables should rest in the cable bushes of the support arm base without excessive
pulling force or stress (Fig. 15).
•
Reattach the cover of the support arm (Fig. 15).
•
When present, switch on the power switches of the TFT displays.
Fig. 15 Cover of the support arm
Mark for the keyboard tray
