Siemens SIPROCESS GA700, Operating Instructions Manual, Page: 165 / 224

Connecting
To connect the field module cable, proceed as follows:
1. Open the center cover on the enclosure of the field control unit.
2. Connect the cable in accordance with the assignment table on the terminal block. An
overview of the terminal assignments can be found on the inside of the cover when removed.
Core num‐
ber
Signal /
property
Number on the termi‐
nal block PCB
Core num‐
ber
Signal /
property
Number on the termi‐
nal block PCB
1 P24 V 70 13 DO 22/1 11
2 P24 V 69 14 DO 22/3 13
3 P24 V 68 15 DO 22/2 12
4 GNDPWR 35 16 DO 23/1 46
5 GNDPWR 34 17 DO 23/3 48
6 GNDPWR 33 18 DO 23/2 47
7 GND 64 19 AO 1P 20
8 CANH 65 20 AO 1N 55
9 CANL 30 21 AO 2P 21
10 DO 21/1 8 22 AO 2N 56
11 DO 21/3 10 23 AO 3P 23
12 DO 21/2 9 24 AO 3N 57
3. Connect the gas connections on the field module, see →Gas connections (Page 50).
4. Check the gas paths for leaks, see →Checking the sample gas path for leaks (Page 74).
5. Close the field control unit enclosure. Tighten the screws with a torque of 3.5 Nm.
See also
Installing/mounting (Page 41)
Field module cable (Page 54)
Wiring
6.3 Field module
Field device
Operating Instructions, 05/2015, A5E35640463-02
53