Communication
9.3 Cyclic output data
SIPLUS HCS3200
46
Operating Instructions, 07/2014, A5E31278506C/002
9.3
Cyclic output data
The cyclic output data can be addressed in the S7 through the process image or I/O
commands.
Process image output (PIQ)
The process image for the outputs PIQ contains the control data for the individual modules.
All addresses are specified as an offset relative to the base address 0.0. The actual
addresses are obtained from the configuration of the overall system.
Table 9- 2
Addressing of outputs
Byte
Bit
Meaning
Description
0
0
= 0: Heating Off
= 1: Heating On
Refer to section Power output control
(Page 39)
1
= 0: Line voltage compensation Off
= 1: Line voltage compensation On
Refer to section Line voltage compen-
2 ... 7
0 (reserved)
1
Power output 1 setpoint
Refer to section Power output control
(Page 39)
2
Power output 2 setpoint
3
Power output 3 setpoint
4
Power output 4 setpoint
5
Power output 5 setpoint
6
Power output 6 setpoint
7
Power output 7 setpoint
8
Power output 8 setpoint
9
Power output 9 setpoint
Summary of Contents for SIPLUS HCS3200
Page 1: ......
Page 2: ......
Page 24: ...Mounting 5 3 Final work SIPLUS HCS3200 24 Operating Instructions 07 2014 A5E31278506C 002 ...
Page 74: ......
