Commissioning
9.4 Commissioning the part-turn actuators
SIPART PS2 with PROFIBUS communication
Operating Instructions, 09/2007, A5E00127926-07
129
Note
Press the increment or decrement buttons additionally to reach the end position
faster.
3.
After checking, move the actuator to a central position. This accelerates the initialization
process.
9.4.2
Automatic initialization of part-turn actuators
Condition
The following conditions must be fulfilled before activating the automatic initialization:
1.
The actuating range of the actuator can be passed through completely.
2.
The actuator shaft is at a central position.
Initializing the positioner automatically
1.
Switch to the "Configuration" mode. Keep the operating modes buttons pressed for more
than 5 s for this purpose. The following is shown on the digital display:
2.
Change the actuator type from linear to the part-turn actuator. Change the parameter
setting using the decrement button. The following is shown on the digital display:
3.
Call the second parameter "YAGL". Press the operating mode button for a short while
for this purpose. This parameter has already been set to 90° automatically. The following
is thus shown on the digital display:
4.
Call the fourth parameter "INITA". Press the operating mode button for a short while
for this purpose. The following is shown on the digital display:
