11.03
5 Commissioning
5.3 Conventional acceptance test
© Siemens AG 2003 All Rights Reserved
SINUMERIK 840D/SIMODRIVE 611 digital SINUMERIK Safety Integrated (FBSI) - Edition 11.03
5-287
Test the cams by traversing them at various axis speeds.
•
Position the cam at the center of the axis. Traverse the cam at various axis
speeds and in the rapid traverse mode. Calculate the time and distance
traveled by the axis until the desired cam signal (NCK-SGA, PLC-SGA) is
output.
Test the limit positions/enstops by passing them at various axis speeds.
•
Locate the limit position/enstops at the center of the axis. Pass the position
at various axis speeds and in the rapid traverse mode. Calculate the
remaining distance traveled by the axis until it is stopped by the configured
stop response. Locate the safe limit in front of the fixed endstop of the axis
at a distance corresponding to the calculated remaining distance plus a
safety margin defined by the machine manufacturer.
Testing the SN
SI function
Testing the SE
SI function
