Procedure
1.
Select the "Parameter" operating area.
2.
Press the "Tool wear" softkey.
3.
Position the cursor at the multitool that is disabled and which you
would like to reactivate.
- OR -
Position the cursor on the tool that you would like to reactivate
again.
4.
Press the "Reactivate" softkey.
The value entered as the setpoint is entered as the new tool life or
workpiece count.
The tool and the multitool are then no longer disabled (the disable
is withdrawn).
Reactivating and positioning
When the "Reactivate with positioning" function is configured, then also the magazine location
at which the selected multitool is located, is positioned to the loading point. You can exchange
the multitool.
Reactivation of all monitoring types
When the "Reactivation of all monitoring types" function is configured, all the monitoring types
set in the NC for a tool are reset during reactivation.
Machine manufacturer
Please refer to the machine manufacturer's specifications.
References
Commissioning Manual SINUMERIK Operate (IM9) / SINUMERIK 840D sl
13.15.8
Relocating a multitool
Multitools can be directly relocated within magazines to another magazine location, which
means that you do not have to unload multitools with the associated tools from the magazine
in order to relocate them to a different location.
When you are relocating a multitool, the system automatically recommends an empty location.
You may also directly specify an empty magazine location.
Tool management
13.15 Working with multitool
Turning
772
Operating Manual, 06/2019, A5E44903486B AB
