Machine manufacturer
You can define further highlight colors in the "sleditorwidget.ini" configuration file.
Please refer to the machine manufacturer's instructions.
Editing a program directly
In the Reset state, you can edit the current program directly.
1.
Press the <INSERT> key.
2.
Place the cursor at the relevant position and edit the program block.
Direct editing is only possible for G code blocks in the NC memory, not for
external execution.
3.
Press the <INSERT> key to exit the program and the edit mode again.
See also
Setting for automatic mode (Page 232)
2.4.6
Operation via softkeys and buttons
Operating areas/operating modes
The user interface consists of different windows featuring eight horizontal and eight vertical
softkeys.
You operate the softkeys with the keys next to the softkey bars.
You can display a new window or execute functions using the softkeys.
The operating software is sub-divided into six operating areas (machine, parameter, program,
program manager, diagnosis, startup), three operating modes and four functions (JOG, MDI,
AUTO, TEACH IN, REF. POINT, REPOS, single block).
Changing the operating area
Press the <MENU SELECT> key and select the desired operating area using
the horizontal softkey bar.
You can call the "Machine" operating area directly using the key on the operator panel.
Press the <MACHINE> key to select the "machine" operating area.
Introduction
2.4 User interface
Turning
50
Operating Manual, 06/2019, A5E44903486B AB
