Parameter
Description
Unit
V2
Retraction distance after each machining step – (for chip breaking only).
Distance by which the drill is retracted for chip breaking.
V2 = 0: The tool is not retracted but is left in place for one revolution.
mm
Clearance dis‐
tance (for swarf re‐
moval only)
● Manual
The clearance distance must be entered manually.
● Automatic
The clearance distance is calculated by the cycle.
V3
Clearance distance – (for swarf removal only and manual limit distance)
Distance to the last infeed depth that the drill approaches in rapid traverse after swarf
removal.
mm
DTB (only for G
code)
● Dwell time at drilling depth in seconds
● Dwell time at drilling depth in revolutions
Note:
DT > 0: The programmed value is effective
DT = 0: The same value is effective as programmed under DTB (DT = DTB)
s
rev
DT
● Dwell time at final drilling depth in seconds
● Dwell time at final drilling depth in revolutions
s
rev
DTS (only for G
code)
● Dwell time for swarf removal in seconds
● Dwell time for swarf removal in revolutions
s
rev
Parameters in the "Input simple" mode
G code program parameters
ShopTurn program parmeters
Input
● simple
RP
Retraction plane
mm
T
Tool name
D
Cutting edge number
F
Linear feedrate
Feedrate per revolution
mm/min
mm/rev
S / V
Spindle speed or
Constant cutting rate
rpm
m/min
Programming technology functions (cycles)
10.1 Drilling
Turning
Operating Manual, 06/2019, A5E44903486B AB
361