3.1
Backing up user data
3.1.1
This is how you backup user data
Application
A backup of the NC data memory is generated using the "Save data" function.
The NC data backup must be performed for every control that has been commissioned in order
to be able to quickly restore the control system in the case of data loss. If the "Create software
backup" function is used when starting up, then it is essential to backup the memory data. With
the data backup, a copy of the limited buffered memory is stored in the permanent memory.
Backup of selected data (e.g. only machine data and no workpiece programs) is not possible.
Data can be backed up without a password: i.e. always!
NOTICE
Data backup
The following procedure is recommended in order to avoid losing data.
● After making important changes, immediately backup data, e.g. after the 1st
commissioning and the 2nd commissioning.
● While the data is being backed up, the control system must neither be operated, nor turned
off.
Data backup using the "Save data" softkey
Preconditions:
● The control system has powered up.
● The power supply voltage is guaranteed during the data backup.
Proceed as follows to generate the internal data backup:
1. Press the <MENU SELECT> key.
2. Select the "Start-up" operating area.
3. Press the "Save data" softkey.
Service cases - software
3.1 Backing up user data
Software and hardware
Service Manual, 08/2018, 6FC5397-5DP40-6BA1
29
