Procedure
1.
The part program or ShopMill program to be processed has been created
and you are in the editor.
2.
Press the "Drilling" softkey.
3.
Press the "Positions" and "Row" softkeys.
The "Position row" input window opens.
Parameter
Description
Unit
LAB
(only for G code)
Repeat jump label for position
PL
(only for G code)
Machining plane
Z0 (only for Shop‐
Mill)
Z coordinate of reference point Z (abs)
mm
X0
X coordinate of the reference point X (abs)
This position must be programmed absolutely in the 1st call.
mm
Y0
Y coordinate of the reference point Y (abs)
This position must be programmed absolutely in the 1st call.
mm
α0
Angle of rotation of the line referred to the X axis
Positive angle: Line is rotated counter-clockwise.
Negative angle: Line is rotated clockwise.
Degrees
L0
L
N
Distance of the 1st position to reference point
Distance between the positions
Number of positions
mm
mm
10.1.13
Grid or frame position pattern (CYCLE801)
Function
● You can use the "Grid position pattern" function (CYCLE801) to program any number of
positions that are spaced at an equal distance along one or several parallel lines.
If you want to program a rhombus-shaped grid, enter angle αX or αY.
● Frame
You can use the "Frame position pattern" function (CYCLE801) to program any number of
positions that are spaced at an equal distance on a frame. The spacing may be different
on both axes.
If you want to program a rhombus-shaped frame, enter angle αX or αY.
Programming technological functions (cycles)
10.1 Drilling
Milling
412
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0
