Mounting
5
5.1
Safety instructions for installation
When carrying out any work, carefully observe the information provided in Chapter "Safety
instructions (Page 13)".
Material damage caused by improper installation
The devices can be damaged through improper installation.
● Install the devices as described in the following sections.
● Take note of the ambient temperatures stated in the technical specifications.
● Avoid any inadmissible load and stress.
Danger due to deposits of dust during installation
When performing mounting and installation work, dirt can accumulates inside the device when
the doors are open. Dirt deposits can can mean that the requirements relating to cleanliness are
no longer fulfilled. If operated with dirt inside the device, then this can result death, serious injury
and material damage.
● Therefore, remove dirt deposits after installation. Then keep the doors closed.
● In the event of contamination from conductive dust particles (e.g. from welding work),
professional cleaning will be required. Contact the service center in this regard.
Danger due to defective seals
When working on the device, seals at the doors, roof panels as well as front, rear and side
panels can be damaged. Operation with defective seals can result in death, serious injury or
material damage.
● Replace the defective seals before commissioning. Observe the environmental conditions
stated in the technical data.
Damage caused by foreign bodies
If foreign bodies are left in the device after installation and maintenance work, this can cause
damage when the device is switched on.
● Before switching on, check as to whether there are any foreign bodies in the device.
Remove any foreign bodies.
SINAMICS SL150 6SL39616RC100AA02
Operating Instructions Rev.201910281458 EXAMPLE
55
