Siemens SINAMICS S150 NEMA, Operating Instructions Manual, Page: 43 / 862

Enclosed Drives
Operating Instructions, 12/2018, A5E36652151A
41
Mechanical installation
3
3.1 Chapter content
This chapter provides information on the following:
● The conditions for transporting, storing, and installing the cabinet unit
● Preparing and installing the cabinet unit
3.2 Transportation and storage
Transport
WARNING
Incorrectly transporting the device
The device can tip over if you transport it incorrectly or if you use non-approved transport
equipment. Death, serious injury, and property damage can result.
•
Ensure that only trained personnel transport the device with approved transport
equipment and lifting tools.
• Comply with the information regarding the center of gravity. A label or stamp with exact
information regarding the center of gravity of the cabinet is attached to each transport
unit.
•
Transport the unit only in the original marked upright position. Do not tilt the device.
• The forks of the forklift must protrude from the rear of the transport pallet. The floor
panels of the transport units do not support loading.
WARNING
Using forklift trucks that are not approved
If the forks are too short, this can cause the transport unit/cabinet to tip over resulting in
death, serious injury, or damage to the cabinet.
• The forks of the forklift must protrude from the rear of the transport pallet. The floor
panels of the transport units do not support loading.
•
Transport the units only with forklifts approved for this purpose.