Table 6-9
PMM Control Menu
Reactive Cur‐
rent mode
2981
Disable
Select output reactive current source method for
PMM control:
• Disabled: I
ds, ref
set to zero, no flux regulator.
• Manual: I
ds, ref
set manually.
• Auto: maintains unity power factor (PF) as
seen from the rotor.
• Manual network: I
ds, ref
set through network.
• Auto phase advance: enable a voltage regula‐
tor to clamp terminal voltage to rated of the
motor. This method maintains unity PF, as
seen from the rotor, below rated speed to pro‐
duce maximum torque per amp of the motor.
Note: For synchronous transfer of a PMM, the Au‐
to and Auto Phase Advance must be disabled.
Output Ids
2982
%
0.0
-100.00 100.00
Ids, ref (reactive current) as percentage of rated
current. Internal code clamps magnitudes from
getting lower than 1.0 %.
PMM for Con‐
veyor
2983
deg
Disable
Selects use of PMM with coordinated startup for
conveyors
Current Offset
Angle
2984
deg
0.0
0.0
180.00
Machine offset angle in electrical degrees
Current Scan
Angle
2985
deg
45.0
0.0
100.00
Maximum scan angle in electrical degrees
Current Scan
Time
2986
deg
10.0
0.0
100.00
Duration of scan in seconds
Current Stabili‐
ty Time
2987
deg
3.0
0.0
100.00
Stabilization of time for current before and after
scan
Table 6-10
Speed Setup Menu (2060) Parameters*
Parameter
ID
Unit
Default
Min
Max
Description
Ratio control
2070
%
100.0
-250.0
250.0
Adjust the scaling of the speed reference value.
Speed fwd max
limit 1
2080
%
100.0
0.0
275.0
The forward maximum speed reference limit 1.
Speed fwd min
limit 1
2090
%
0.0
0.0
200.0
The forward minimum speed reference limit 1.
Speed fwd max
limit 2
2100
%
100.0
0.0
200.0
The forward maximum speed reference limit 2.
Speed fwd min
limit 2
2110
%
0.0
0.0
200.0
The forward minimum speed reference limit 2.
Speed fwd max
limit 3
2120
%
100.0
0.0
200.0
The forward maximum speed reference limit 3.
Parameter Assignment/Addressing
6.5 Options for Drive Menu (2) - first part
Control Manual
Operating Manual, A5E50491925A
103
Summary of Contents for SINAMICS PERFECT HARMONY GH180
