p3985
Master control mode selection / PcCtrl mode select
Access level: 3
Calculated: -
Data type: Integer16
Can be changed: T, U
Scaling: -
Dynamic index: -
Unit group: -
Unit selection: -
Function diagram: -
Min:
0
Max:
1
Factory setting:
0
Description:
Sets the mode to change over the master control / LOCAL mode.
Value:
0:
Change master control for STW1.0 = 0
1:
Change master control in operation
DANGER
When changing the master control in operation, the drive can manifest undesirable behavior - e.g. it can accelerate
up to another setpoint.
r3986
Number of parameters / Param count
Access level: 3
Calculated: -
Data type: Unsigned16
Can be changed: -
Scaling: -
Dynamic index: -
Unit group: -
Unit selection: -
Function diagram: -
Min:
-
Max:
-
Factory setting:
-
Description:
Displays the number of parameters for this drive unit.
The number comprises the device-specific and the drive-specific parameters.
Dependency:
See also: r0980, r0981, r0989
r3988[0...1]
Boot state / Boot_state
Access level: 4
Calculated: -
Data type: Integer16
Can be changed: -
Scaling: -
Dynamic index: -
Unit group: -
Unit selection: -
Function diagram: -
Min:
0
Max:
800
Factory setting:
-
Description:
Index 0:
Displays the boot state.
Index 1:
Displays the partial boot state
Value:
0:
Not active
1:
Fatal fault
10:
Fault
20:
Reset all parameters
30:
Drive object modified
40:
Download using commissioning software
50:
Parameter download using commissioning software
90:
Reset Control Unit
100:
Start initialization
101:
Only for internal Siemens use
110:
Instantiate Control Unit basis
111:
Only for internal Siemens use
112:
Only for internal Siemens use
113:
Only for internal Siemens use
114:
Only for internal Siemens use
115:
Parameter download using commissioning software
Parameters
7.2 Parameter list
SINAMICS G120X converter
Operating Instructions, 06/2019, FW V1.01, A5E44751209B AC
851
