Description:
Displays the commissioning steps that have been carried out.
Bit field:
Bit
Signal name
1 signal
0 signal
FP
00
Motor/control parameters calculated (p0340 = 1, p3900 > 0) Yes
No
-
02
Motor data identification carried out at standstill (p1910 = 1) Yes
No
-
03
Rotating measurement carried out (p1960 = 1, 2)
Yes
No
-
08
Identified motor data are automatically backed up
Yes
No
-
11
Automatic parameterization as Standard Drive Control
Yes
No
-
12
Automatic parameterization as Dynamic Drive Control
Yes
No
-
14
First motor commissioning
Yes
No
-
15
Equivalent circuit diagram parameters changed
Yes
No
-
18
Circle identification executed
Yes
No
-
Note
The individual bits are only set if the appropriate action has been initiated and successfully completed.
The identification final display is reset when changing the type plate parameters.
r3926[0...n]
Voltage generation alternating base voltage amplitude / U_gen altern base
Access level: 4
Calculated: -
Data type: FloatingPoint32
Can be changed: -
Scaling: -
Dynamic index: MDS, p0130
Unit group: -
Unit selection: -
Function diagram: -
Min:
- [V]
Max:
- [V]
Factory setting:
- [V]
Description:
Displays the base voltage for the alternating voltage in the context of motor data identification.
0:
No alternating voltages. The function is deactivated.
<0:
Automatic determination of the base voltage and wobbulation / self-setting based on the converter and the connected
motor.
Otherwise:
Base voltage for alternating current generation in volts (wobbulation active).
r3927[0...n]
Motor data identification control word / MotID STW
Access level: 3
Calculated: CALC_MOD_ALL Data type: Unsigned32
Can be changed: -
Scaling: -
Dynamic index: DDS, p0180
Unit group: -
Unit selection: -
Function diagram: -
Min:
-
Max:
-
Factory setting:
-
Description:
Successfully completed component of the last motor data identification carried out.
Bit field:
Bit
Signal name
1 signal
0 signal
FP
00
Stator inductance estimate no measurement
Yes
No
-
02
Rotor time constant estimate no measurement
Yes
No
-
03
Leakage inductance estimate no measurement
Yes
No
-
05
Determine Tr and Lsig evaluation in the time range
Yes
No
-
06
Activate vibration damping
Yes
No
-
07
Deactivate vibration detection
Yes
No
-
11
Deactivate pulse measurement Lq Ld
Yes
No
-
12
Deactivate rotor resistance Rr measurement
Yes
No
-
14
Deactivate valve interlocking time measurement
Yes
No
-
15
Determine only stator resistance, valve voltage fault, dead
time
Yes
No
-
Parameters
7.2 Parameter list
SINAMICS G120X converter
Operating Instructions, 06/2019, FW V1.01, A5E44751209B AC
847
