Siemens SINAMICS BOP-2, Operating Instructions Manual

Page: 24 / 54

Control
Basic Operator Panel 2 (BOP-2)
24
Operating Instructions, 02/2016, A5E37143404B AA
Setpoint
The setpoint value determines the speed at which the motor runs as a percentage of the
nominal motor speed. It should be noted that this setpoint setting is only valid while HAND
mode is active. When the Inverter is set back to AUTO mode, the setpoint previously used in
AUTO mode becomes the valid setpoint.
Note
Torque setpoint
In HAND mode the torque setpoint (if the Inverter is in torque control mode) cannot be
directly modified using the setpoint speed function of the BOP-2; although the motor can still
be stopped and started using the and keys respectively.
To change or modify the value of the setpoint, the actions shown in the following figure
should be performed:
Image 7-1 Setpoint function