Siemens SIMOTICS T-1FW3, Configuration Manual

Page: 71 / 354

Mechanical properties
3.10 Bearing change intervals
1FW3 complete torque motors
Configuration Manual, 08/2020, A5E46027705B AA
69
3.10 Bearing change intervals
Bearing lifetime and regreasing interval
The bearings for the complete torque motors are greased for life and designed for operation
at a minimum ambient temperature of - 15 °C.
Note
Bearings without regreasing system
For bearings without regreasing system (SH 150 and SH 200), we recommend that the
bearings are replaced after approx. 20000 operating hours for an ambient temperatures up
to a maximum of 40°C, or after 5 years (after delivery) at the latest.
The bearing lifetime is reduced by 50 % when motors are mounted vertically. This is the
reason that we recommend that a regreasing system is used when motors are mounted
vertically.
Regreasing system (option for 1FW315x and 1FW320x, standard for 1FW328x)
If the 1FW3 is equipped with regreasing system (bevel lubricating nipple) for the DE and
NDE bearings, then the bearing change interval increases according to the table "Bearings
with regreasing system". Comply with the regreasing intervals and ensure that the
temperature does not exceed a maximum of 40 °C.
Table 3- 12 Bearing change interval and regreasing
SH 150 SH 200 SH 280
Bearing change interval with permanent
grease lubrication, horizontal mounting
position
20,000 h at max. 40 °C
ambient temperature
20,000 h at max. 40 °C
ambient temperature
---
Regreasing K40
See table "Bearings with
regreasing system"
K40
See table "Bearings with
regreasing system"
Regreasing in the
standard
See table "Bearings with
regreasing system"
Table 3- 13 Bearings with regreasing system (optional for 1FW315 ❑ and 1FW320 ❑ )
Motor Bearing change interval with re-
greasing [h]
Regreasing intervals [h]
1FW315 ❑ Hollow shaft 40000 10000
1FW315 ❑ plug-on shaft 60000 10000
1FW315 ❑ Solid shaft 60000 10000
1FW320 ❑ Hollow shaft 40000 10000
1FW320 ❑ plug-on shaft 60000 10000
1FW320 ❑ Solid shaft 60000 10000
1FW328 ❑ -2 n
N
= 150/250 hollow
shaft
40000 10000
1FW328 ❑ -3 n
N
= 400 hollow shaft 40000 8000
1FW328 ❑ -3 n
N
= 600 hollow shaft 40000 8000