Siemens SIMOTICS S-1FG1, Operating Instructions Manual

Page: 22 / 170

Description
2.2 Technical features and ambient conditions
SIMOTICS S-1FG1 servo geared motor
20
Operating Instructions, 07/2019, A5E47360747B AA
If you wish to use special versions and design variants whose specifications vary from the
motors described in this document, then contact your local Siemens office.
If you have any questions regarding the intended usage, please contact your local Siemens
office.
The 1FG1 is intended for industrial or commercial plants.
The 1FG1 is designed for operation in sheltered areas under normal climatic conditions,
such as those found on shop floors.
For more detailed information, refer to Chapter "Environmental conditions (Page 23)".
The 1FG1 is certified only for operation through a converter.
Any other use of the 1FG1 is considered to be incorrect use.
Compliance with all specifications in the operating instructions is part of correct usage.
Observe the details on the rating plate.
2.2 Technical features and ambient conditions
2.2.1 Directives and standards
Standards that are complied with
The motors of the type series SIMOTICS S, SIMOTICS M, SIMOTICS L, SIMOTICS T,
SIMOTICS A, called "SIMOTICS motor series" below, fulfill the requirements of the following
directives and standards:
● EN 60034-1 (IEC 60034-1) - Rotating electrical machines – Dimensioning and operating
behavior
● EN 60204-1 (IEC 60204-1) - Safety of machinery – Electrical equipment of machines;
general requirements
Where applicable, the SIMOTICS motor series are in conformance with the following parts of
EN 60034:
Feature Standard
Degree of protection EN 60034-5 (IEC 60034-5)
Cooling
1)
EN 60034-6 (IEC 60034-6)
Type of construction EN 60034-7 (IEC 60034-7)
Connection designations EN 60034-8 (IEC 60034-8)
Noise levels
1)
EN 60034-9 (IEC 60034-9)
Temperature monitoring EN 60034-11 (IEC 60034-11)
Vibration severity grades
1)
EN 60034-14 (IEC 60034-14)
1)
Standard component, e.g. cannot be applied to built-in motors