6.3.3
Connecting the speed encoder
The speed encoder is connected at the terminal box using a plug connection
①
. This is located
on the terminal box enclosure.
Figure 6-7
Detailed view: Plug-in connection
Note
The plug-in connection may differ from the standard layout in the case of special orders. For
versions without speed encoder, connection thread M16x1.5 is located here.
Connecting a speed encoder via DRIVE-CLiQ
The signal connection between the motor and the converter is established via the DRIVE‑CLiQ
cable MOTION‑CONNECT.
● Always use prefabricated cables from Siemens. These cables reduce the mounting/
installation time and costs and increase operational reliability.
● Push the connector of the DRIVE‑CLiQ cable into the socket until the catch spring latches
into place. Pay attention to the coding of the connector.
Cable outlet directions
The sensor module is mounted on the motor terminal box. The sensor module can be rotated
through approximately 235°. You can change the cable outlet directions by rotating the sensor
module, as shown in the diagram below.
NOTICE
Damage to the sensor module
You can damage the sensor module if you turn it with a pipe wrench, a hammer, or similar
tools.
Turn the sensor module by hand. The typical torque is approx. 4 ... 8 Nm.
Electrical connection
6.3 Auxiliary circuits
SIMOTICS M-1PH8 1PH818., 1PH822., 1PH828.
82
Operating Instructions 10/2017
Summary of Contents for SIMOTICS M-1PH818
