Siemens SIMOTICS HV M, Operating Instructions Manual

Page: 30 / 136

● When lifting the machine, refer to the information on the lifting plate or in the "Technical
Data and Drawings":
– Comply with the specified spreading angles.
– Do not exceed the maximum lifting acceleration and lifting speed specified on the lifting
plate. Lift the machine without jerking it.
Acceleration a ≤ 0.4 g (≈ 4 m/s
2
)
Velocity v ≤ 20 m/min
● Use only the attachment points provided on the stator frame for lifting, such as lifting eyes
or ring bolts or the lifting eyebolts on the bearing shield.
WARNING
Transport for a different type of construction
The machine or the machine set may be lifted and transported only using the load handling
attachments at the intended positions. Otherwise, the machine may tip over, slip in the
direction of lifting or fall.
This can result in death, serious injury or material damage.
1. Use only the attachment points (eyebolts, etc.) on the stator frame.
2. Use suitable rope guiding or spreading devices. You will find the weight of the motor
on the rating plate.
WARNING
Center of gravity is not at the center.
If the center of gravity of a load is not located centrally between the attachment points,
the motor can tip over or slip out of the lifting equipment and fall when it is being transported
or lifted. This can result in death, serious injury or material damage.
1. Always take account of the center of gravity when transporting or lifting the motor. The
center of gravity of the machine is specified in the dimension drawing.
2. Comply with the handling instructions on the machine when transporting it. If the center
of gravity is not located centrally between the attachment points, position the hoisting
hook above the center of gravity.
3. Be aware of the possibility of different loads on the sling ropes or lifting straps and the
carrying capacity of the lifting equipment.
NOTICE
Risk of corrosion and reduction of the degree of protection
Empty holes can corrode; the degree of protection may then be no longer guaranteed.
● Do not remove the factory-fitted load suspension device. In operation, the load-
suspension device must remain screwed in.
● If you do remove the load-suspension device, then seal the holes so that they are
airtight.
Preparations for use
4.15 Transport and storage
SIMOTICS HV M 1RN76308PR900CG0-Z
30
Operating Instructions 07/2018