Siemens SIMOTICS HV M, Operating Instructions Manual

Page: 13 / 136

Safety information
2
2.1 Information for those responsible for the plant
This machine has been designed for use in industrial plants in accordance with Directive
2006/42/EC ("Machinery Directive"). Commissioning in the European Community is forbidden
until the plant into which the machine will be installed has been shown to conform with this
directive. Please observe the country-specific regulations when using the machine outside the
European Community.
Follow the local and industry-specific safety and setup regulations.
The persons responsible for the plant must ensure the following:
● Planning and configuration work and all work carried out on and with the machine is only
to be done by qualified personnel.
● The operating instructions must always be available for all work.
● The technical data as well as the permissible installation, connection and operating
conditions are always consequentially taken into account.
● The specific setup and safety regulations as well as regulations on the use of personal
protective equipment are observed.
Note
Use the services and support provided by the local service center (Page 121) for planning,
installation, commissioning and service work.
In the individual chapters of this document, you will find warning and safety instructions that
must be observed without fail, for your own safety, to protect other people and to avoid material
damage.
Observe the following safety instructions for all activities on and with the machine.
2.2 The five safety rules
For your own personal safety and to prevent material damage when carrying out any work,
always observe the safety-relevant instructions and the following five safety rules according
to EN 50110‑1 "Working in a voltage-free state". Apply the five safety rules in the sequence
stated before starting work.
Five safety rules
1. Disconnect the system.
Also disconnect the auxiliary circuits, for example, anti-condensation heating.
2. Secure against reconnection.
3. Verify absence of operating voltage.
SIMOTICS HV M 1RN76308PR900CG0-Z
Operating Instructions 07/2018
13