![Siemens SIMOTICS DP series Operating Instructions Manual Download Page 13](http://html.mh-extra.com/html/siemens/simotics-dp-series/simotics-dp-series_operating-instructions-manual_379018013.webp)
Standard motors SH 63 ... 355
Operating Instructions, 12/2018, A5E38483075A
11
Safety information
2
2.1
Information for those responsible for the plant or system
This electric machine has been designed and built in accordance with the specifications
contained in Directive 2014/35/EU ("Low-Voltage Directive") and is intended for use in
industrial plants. Please observe the country-specific regulations when using the electric
machine outside the European Community. Follow the local and industry-specific safety and
setup regulations.
The persons responsible for the plant must ensure the following:
●
Planning and configuration work and all work carried out on and with the machine is only
to be done by qualified personnel.
●
The operating instructions must always be available for all work.
●
The technical data as well as the specifications relating to the permissible installation,
connection, ambient and operating conditions are taken into account at all times.
●
The specific setup and safety regulations as well as regulations on the use of personal
protective equipment are observed.
Note
Use the services and support provided by the local service center for planning,
installation, commissioning and service work.
2.2
The 5 safety rules
For your own personal safety and to prevent material damage when carrying out any work,
always observe the safety-relevant instructions and the following five safety rules according
to EN 50110-1 "Working in a voltage-free state". Apply the five safety rules in the sequence
stated before starting work.
5 safety rules
1.
Disconnect the system.
Also disconnect the auxiliary circuits, for example, anti-condensation heating.
2.
Secure against reconnection.
3.
Verify absence of operating voltage.
4.
Ground and short-circuit.
5.
Provide protection against adjacent live parts.
To energize the system, apply the measures in reverse order.