Siemens SIMOTICS A 1FU8, Operating Instructions Manual

Page: 161 / 226

Assembly
5.5 Alignment and fastening
1FU8
Operating Instructions, 02/2016, 5 610 70000 02 000
47
Mounting output transmission elements
● When mounting output transmission elements (coupling, gear wheel, belt pulley etc. ) use
the thread at the shaft end.
If possible, heat up the output transmission elements as required.
● Use a suitable device when withdrawing output elements.
● When mounting or withdrawing, do not apply any blows, for example with a hammer or
similar tool, to the parts to be mounted or withdrawn.
● Only transfer radial or axial forces specified in the catalog to the motor bearings via the
shaft extension.
5.4.6 Noise emission
CAUTION
Hearing damage when operating synchronous motors
If you exceed the permissible sound pressure level, hearing damage can occur when
operating synchronous motors at their rated power.
Observe the maximum permissible sound pressure level according to the ISO 1680
standard. The maximum permissible sound pressure level is 70 dB (A).
5.5 Alignment and fastening
Observe the following when aligning and mounting:
● Ensure a flat and uniform contact surface for foot and flange mounting.
● Precisely align the machine when couplings are used.
● Ensure that the mounting surfaces are clean and free of any dirt.
● Remove any anti-corrosion protection using white spirit.
● Avoid installation-related resonances with the rotating frequency and twice the line
frequency.