LEDs and connectors
3.2 TIM 4R-IE DNP3
TIM DNP3
58
System Manual, 12/2015, C79000-G8976-C253-04
3.2.3
Pinout of the ports
RS-232/RS-485 interfaces
The plugs for the two serial ports are designed as a 9-pin D-sub miniature connectors
(male). The pinout of the two connectors is identical and is shown in the following table. As
an RS-232 port, the pinout corresponds to that of a standardized PC connector.
This is a combined RS-232/RS-485 port. As default, the ports are set to RS-232. The
switchover to RS-485 is set in the STEP 7 configuration and is therefore part of the
configuration data of the TIM 4R-IE DNP3.
Table 3- 7
Pinout of the connector of the combined RS-232/RS-485 port
Illustration
Pin no.
Signal name
Signal direction Remark
1
DCD
Input
2
RXD
Input
Switching over to RS-485
in the configuration
3
TXD
Output
Switching over to RS-485
in the configuration
4
DTR
Output
5
GND
6
-
7
RTS
Output
8
CTS
Input
9
-
Ethernet ports
The two Ethernet ports are designed as 8-pin RJ-45 Western jacks. The pinout is shown in
the following table.
Table 3- 8
Pinout of the RJ-45 Western jack for the Ethernet port
Illustration
Pin no.
Signal name
Signal direction
Remark
1
TXD+
Output
2
TXD-
Output
3
RXD+
Input
4
-
5
-
6
RXD-
Input
7
-
8
-
Summary of Contents for SIMATIC TIM 3V-IE DNP3
