Siemens SIMATIC TD 200, User Manual

Page: 27 / 132

2-5
SIMATIC TD 200 Operator Interface
C79000-G7076-C272-01
Enabling Time-of-Day, Force Function, and Password Protection
The dialog box shown in Figure 2-3 allows you to enable Menu mode options and
set an edit password.
The Time-of-Day (TOD) and force menu selections allow you to selectively enable
the TOD Clock menu and/or the Force menu. Once a selection is enabled, you are
allowed to access that menu in the TD 200. If the menu is not enabled, it does not
appear in the TD 200 Menu mode.
The password protection selection allows you to enable a four-digit password (from
0000 to 9999). The password controls the ability of the operator to edit variables
embedded in a message and to access the Menu mode. If you enable password
protection, a field appears in the dialog box for you to set the password. This
password is not the CPU password. This password is stored in the TD 200
parameter block and only affects access to editing functions in the TD 200.
For this example, use the option buttons to select the modes shown in Figure 2-3.
Set 1111 as your password.
TD 200 Configuration Wizard
Cancel Next >
The TD 200 can be configured to allow the user to set the Time of Day
clock in the PLC, and to Force I/O in the PLC. These options may also
be password-protected, so that a user may only access them after
entering the correct 4-digit password.
< Prev
Would you like to enable the Time-of-Day (TOD) menu on your TD 200?
Yes
No
Would you like to enable the force menu on your TD 200?
Yes
No
Would you like to enable password protection?
Yes
No 1111 Password (0000 - 9999):
TD200
Figure 2-3 Wizard: Time-of-Day Clock, Force I/O, and Password Protection
Configuring the TD 200