Siemens SIMATIC RUGGEDCOM RSG2100P, Installation Manual

Page: 30 / 58

Device Management
3
This section describes how to connect to and manage the device.
3.1 Connecting to the Device
The following describes the various methods for accessing the RUGGEDCOM
RSG2100P console and Web interfaces on the device. For more detailed instructions,
refer to the "RUGGEDCOMROS Configuration Manual" for the RUGGEDCOM
RSG2100P.
RS232 Console Port
Connect a workstation directly to the RS232 console port to access the boot-time
control and RUGGEDCOM RSG2100P interfaces. The console port provides access to
RUGGEDCOM RSG2100P's console and Web interfaces.
NOTICE
The serial console port is intended to be used only as a temporary connection during
initial configuration or troubleshooting.
Connection to the console port is made using an RJ45-to-DB9 console cable. The
following is the pin-out for the console port:
1 8
Figure 3.1 RJ45 Console Port Pin Configuration
Pin
RJ45 Male DB9 Female
Name Description Comment
1 6 DSR
a
Data Set Ready
2 1 DCD
a
Carrier Detect Reserved (Do Not Connect)
3 4 DTR
a
Data Terminal Ready
4 5 GND Signal Ground
5 2 RxD Receive Data (to DTE)
6 3 TxD Transmit Data (from DTE)
7 8 CTS
b
Clear to Send
8 7 RTS
b
Read to Send
RUGGEDCOM RSG2100P
Installation Manual, 04/2022, C79000-G8976-1041-20
21