Siemens SIMATIC RI 45 PIII Series, Manual

Page: 120 / 132

7-12
RI 45 PIII, Manual
C79000-G7076-C817-01
This setting determines whether the message
Press <Ctrl> <A> for SCSISelect (TM) Utility!
appears when you power up the system.
Even if you disable display of this message, you can still call SCSI Setup
using the Ctrl + A key combination when starting the system.
Enabled The message is displayed when powering up (default setting).
Disabled The message is not displayed when powering up.
This setting enables booting from a bootable CD-ROM
Enabled Booting from a CD-ROM is possible (default setting).
Disabled Booting from a CD-ROM is not possible.
This setting determines whether the SCSI BIOS supports a hard disk drive
with more than 1024 cylinders. Enabled is the default setting.
Enabled Hard disk drives with more than 1024 cylinders are supported
(default setting).
Disabled Hard disk drives with more than 1024 cylinders are not sup-
ported.
7.3.5 SCSI Disk Utilities
If you call the menu item SCSI Disk Utilities, you obtain a list of all devices
connected to the SCSI bus. You also get to select from two menus for hard
disk drives: Verify and Format Disk.
You can use Verify to verify a selected hard disk drive. All defects thus
identified are entered in the hard disk’s existing error list.
You can use Format Disk to format a selected hard disk drive in low-level
format. Hard disks are usually already formatted in low-level format. Use
this menu item only if you want to delete the entire hard disk and create a
new error list.
Display Ctrl + A
Message During
BIOS Initialization
BIOS Support for
Bootable CD-ROM
BIOS Support for
Int 13 Extensions
Verify
Format Disk
SCSI Option