Configuring
5.2 Configuration via PROFINET IO (STEP 7)
SIMATIC RF360R
30
Configuration Manual, 03/2022, C79000-G8976-C629-02
"Configuration management" parameter group
You can load or save configuration data in this parameter group.
Table 5- 2
Parameters of the "Configuration management" parameter group
Parameter
Description
User name
1)
User name of a user created on the reader
Note that the user must have the required rights.
Password
1)
Input box for the password of the selected user
Load configuration to
device
Loading configuration data into the reader from the STEP 7 project.
Save configuration in
project
Saving configuration data of the reader in the current STEP 7 project.
1)
User name and password must only be entered when the user management of the reader in the WBM is enabled.
Requirement
The following requirements must be met so that configuration data can be loaded or saved:
•
The "PROFINET interface [X1]" parameter contains the correct IP address of the reader.
•
The specified user has the required rights to perform the download/upload.
•
Note that https is not supported with TIA Portal versions ≤ V17.
"Module parameters" parameter group
In this parameter group, you can configure all module-specific parameters of the reader.
Table 5- 3
Parameters in the "Module parameters" parameter group
Parameter
Parameter value
Default value
Description
Diagnostic interrupt of
the device
On
Off
On
Switch the diagnostic interrupt messages of the
reader on/off.
Parameter group "Module parameters > General parameters" of the submodules (connected
devices)
In this parameter group, you can configure all module-specific parameters of the connected
devices. Note that some of the following parameters are module-specific. For some module
types, not all parameters are displayed.
Depending on the Ident device that is connected to the respective interface, you must use the
matching submodule:
•
Reader configuration: Submodule for connecting the SIMATIC RF200 and RF300 readers
