RF-MANAGER RF310M software
9.3 Application mode "Mobile"
SIMATIC RF310M Mobile Reader
Operating Instructions, 10/2013, J31069-D0191-U001-A6-7618
73
9.3.2.6
Progress and timeout display
With the read and write functions, communication takes place with the transponder. The
progress of the currently executed function is indicated, acoustic signals are output, and also
a timeout where applicable:
Progress display and acoustic signal with read/write operations
During the data transmission, the progress of the executed function is displayed on a
bargraph:
Figure 9-10 Progress display in the case of the tag function
The tag function is not interrupted if you briefly move the tag out of the read field. All read
and write operations are repeated until a tag has been detected.
You can stop the respective read or write operation at any time using the "Cancel" button.
Acoustic signals
An acoustic signal is output when the read or write operation has been completed
successfully.
With longer data blocks, an acoustic signal is output following each read block.
If an operation is canceled as a result of an error or by the user, a different audible signal is
output.
Timeout display in the case of the tag function
If the tag remains unedited for longer than 20 seconds, the function is interrupted and the
following message window appears:
Figure 9-11 Timeout display in the case of the tag function
You can now stop the command completely with "Yes" or continue it with "No". If you retry,
the interrupted command is continued at the point of interruption.
