Siemens SIMATIC PC BI45, Technical Description, Page: 41 / 42

1-35
SIMATIC PC BI45/FI45 PII, Technical Description
C79000-G7076-C794-03
1.7 Error Diagnostics
Error Cause Remedy
Power-ON LED does not light up PC is switched off
Power supply is not properly
connected
Check power supply
connections, power cable and
power plug
The “Invalid configuration
information... Press the F1 key for
continue, F2 to run Setup utility”
appears on the screen Incorrect configuration data
Buffer battery is low or damaged
Press “F2” key, check the
configuration data in SETUP,
enter any default values, and
check error messages in the first
SETUP menu
The “No boot device available”
appears on the screen There is no boot diskette in the
drive
Wrong hard disk drive set in
SETUP
Use the “Fixed disk function” in
SETUP
“Keyboard stuck key failure”
message appears A key has become blocked
during the system keyboard self-
test Check the keyboard
Restart the system
Booting of the PC aborted after
several beeps An error has occured during the
system self-test Check the hardware
Every time a key is pressed, a beep
is heard and no characters appear Keyboard buffer overflow <CTRL> <PAUSE>
Not-ready message when trying to
write to a diskette No diskette has been inserted
Diskette has not been formatted
Insert diskette
Format diskette
Write-protect error when trying to
write to a diskette Diskette write-protect activated
Write-protect hole open on 3.5”
diskette
Cancel write protection
“EPROM TSR Interface disabled,
check Power Management”
message “Programming Interface” has
been disabled in SETUP Enable “Programming Interface”
in SETUP under submenu “FI
Hardware options”
COM1,COM2, LPT1 or MPI/DP
do not respond Ports have been disabled in
SETUP Enable COM1,COM2, LPT1 or
MPI/DP in SETUP under
submenu “FI Hardware
Options.”
<\> key labeling missing No original keyboard German keyboard: <ALTGr >
< ß >, or <ALT> <9> <2>
International keyboard: <ALT>
<9> <2>
<\> key is not displayed Wrong keyboard driver is being
used Load correct keyboard driver
<ALT> <9> <2>
Mouse not working Trackball does not rotate
No or wrong mouse driver is
used
Clean trackball and housing
Load correct mouse driver
Mouse pointer cannot be moved PS/2 port has been disabled in
SETUP Check SETUP settings
Mouse pointer moving erratically Trackball dirty Clean trackball and housing
Drive cover cannot be opened Filter cap not properly fixed Push filter cap in proper position
System Unit