Frequently Asked Questions
3
General
Q:
How do I power a USB DVD-ROM drive or USB hard disk using the RUGGED-
COM APE1808 USB port?
A:
The RUGGEDCOM APE1808 USB port is limited in the amount of power it can
provide. Use a powered hub to employ devices such as these.
Q:
How can I re-install the software platform on the RUGGEDCOM APE1808?
A:
There are two possible options:
• Return the RUGGEDCOM APE1808 module to Siemens and request a re-in-
stall. This service is not covered by warranty.
• Restore the backup image that was made before commissioning the
RUGGEDCOM APE1808 module.
Linux
Q:
How do I recover an image of the original factory settings?
A:
Siemens strongly recommends creating a backup image of the RUGGEDCOM
APE1808 before it is configured. If this image is available, it can be easily re-
stored.
If an original backup image is not available, contact Siemens Customer Support
for assistance. In most cases, the RUGGEDCOM APE1808 module must be re-
turned to the factory to be re-imaged. This service is not covered by warranty.
Q:
Does the RUGGEDCOM APE1808 support a Real Time Operating System
(RTOS)?
A:
The software distributed by Siemens does not include an RTOS component.
However, this software could be installed.
Q:
Does the RUGGEDCOM APE1808 have a serial port?
A:
The RUGGEDCOM APE1808 does not have serial ports.
RUGGEDCOM APE1808
Configuration Manual, 11/2019, C79000-G8976-1415-03
17
