The figure below shows you an example of the parameter assignment of an IO-Link device:
Figure 3-4 Setting the parameter values of the IO-Link device
Starting from the displayed defaults, you can edit and save the values in the defined value
range.
The configuration of the IO-Link system and the parameters of the devices are available to the
IO-Link system and the entire automation project. You have the option of saving and printing
the configuration and the parameters.
It is not possible to change parameters in online mode.
3.1.2
Configuration without S7-PCT
Introduction
The following sections describe how you configure your IO-Link master without the S7-Port
Configuration Tool (S7-PCT).
Your options for configuration of the IO-Link system without S7-PCT are limited.
You can configure the port of the IO-Link master using STEP 7 or the GSD file, but you cannot
set any parameters of the lower-level IO-Link devices.
22
IO-Link system
Function Manual, 07/2022, A5E31637677-AC
Integration into the automation system
3.1 Configuration of the IO-Link system
