Configuring the operating system
6.6 Changing HMI device settings
Mobile Panel 277F IWLAN
Operating Instructions, 12/2007, A5E01003940-01
159
Procedure for displaying memory information
NOTICE
"Memory" tab
Do not change the memory distribution in the "Memory" tab.
Only applies for the usage of options:
An alteration to the memory distribution may be necessary. Please refer to the
accompanying documentation for the option for additional information.
Proceed as follows:
1.
Change to the "Memory" tab.
The memory information is displayed.
1.
Close the dialog.
6.6.10
Activating vibration alarm
Introduction
You can activate a vibration alarm for the HMI device. The vibration alarm will be triggered in
the current project under the following circumstances:
● You leave the effective range with the HMI device without logging the HMI device off from
the effective range.
● The charging status of the main battery is critical.
Requirements
You have opened the "OP Properties" dialog box, "Vibration Alarm" tab, by touching the
"OP"
icon.
