Siemens Simatic Field PG, Manual

Page: 89 / 142

6-1
SIMATIC Field PG Manual
A5E00075760-04
Error Diagnostics
What Does This Chapter Contain?
This chapter will help you to locate, identify, and in some cases eliminate simple
errors and faults.
Error/Fault Remedy
Device LED does not light up
•
PG is switched off
•
Power supply not properly connected
•
Battery run down or not installed
•
Press the Power Button
•
Check the power supply, power cable, and power
plug
•
Charge or install the battery
External monitor remains dark
•
LCD enabled is entered in SETUP
•
Enter CRT enabled or SIMULTANEOUS in SETUP
Message on the Display :”Invalid configuration information... Press the F1 key for continue, F2 to
run Setup utility”
•
Configuration data not correct
•
Hit the “F2” key, check the configuration data in the
SETUP program, if necessary adapt the default
values, check the error messages in the first SE-
TUP menu
Message on the Display ”No boot device available” NTLDR not found, check boot data carrier
•
No bootable disk in drive A:
•
Wrong hard disk type entered in SETUP
•
Replace the disk with a boot disk
•
Use the “Autodetect Fixed Disk” function
Message on the Display : ”Keyboard stuck key failure”
•
A key became blocked during the self-test of
the keyboard
•
Check the keyboard. Restart the system if need be.
Every time a key is pressed, a beep is heard and no characters are displayed
•
Keyboard buffer overflow
•
<CTRL> <PAUSE>
< \ > key does not exist
•
Wrong keyboard driver
•
German keyboard: <ALTGr> <ß>
•
International keyboard : <\> key
After power on: error message: “Battery needs calibration cycle”
•
Battery is no longer calibrated
•
Confirm error message with the “F1” key
•
Run a teach-in cycle
6