Siemens SIMATIC Field PG P4, Manual

Page: 36 / 144

Getting Familiarized with the SIMATIC Field PG P4
2-18
SIMATIC Field PG P4 Manual
A5E00180080-04
2.6.3 Optical Drive
Depending on the device configuration, it can come with a DVD-ROM/CD-RW or a
DVD
+
R/
+
RW drive. For example, you can read the electronic manual of the
supplied Backup PG DVD with this drive.
Opening the Drawer
Switch on the programming device. By briefly pressing the eject button, the drawer
springs out slightly. Now pull the drawer out until it clicks into position.
Inserting / Removing the data medium
Now insert the data medium in the drawer with the labeling face up, and press it
firmly down into the center of the turntable. To remove the data medium, hold it by
the edges and pull upwards.
Closing the Drawer
Push in the drawer until it closes completely. Do not press the eject button.
Emergency removal
By pushing a pin into the emergency release opening (for example, a paper clip)
while the device is switched off, you can force the drawer to open.
Notice
To ensure that the open drawer of the drive is not exposed to excessive force,
always support the front of the drawer with one hand while inserting or removing
the data medium with the other.
The data medium is tested when you close the drive and the access LED on the
drive flashes to indicate that the test is in progress:
– if the LED does not stop flashing the data medium is bad but readable,
– if the LED flashes several times and then remains on, the data medium is not
readable and defective.
Caution
Risk of data loss and damage to the drive.
Optical drives are highly sensitive to excessive vibration. Vibration during
operation can damage the drive or the data medium.
The burning operation with the DVD-ROM/CD-RW and DVD
+
R/
+
RW drive is only
permissible in an untroubled environment and under an ambient temperature not
exceeding 35
C.