Preface
ET 200S Distributed I/O System - Fail-Safe Modules
Installation and Operating Manual, 08/2008, A5E00103686-07
5
Documentation
Brief Description of Relevant Contents
The
S7 Distributed Safety, Configuring and Programming
manual and online help describe
the following:
•
Configuration of the fail-safe CPU and the fail-safe I/O
•
Programming of the fail-safe CPU in fail-safe FBD or LAD
For integration in the S7
Distributed Safety F-system
Depending on which F-CPU you use, you will need the following documentation:
•
The operating instructions
S7-300, CPU 31xC and CPU 31x: Configuration
describes
the configuration, installation, addressing and commissioning of S7-300 systems.
•
The
CPU 31xC and CPU 31x, Technical Data
manual describes the standard functions
of the CPU 315F-2 DP and PN/DP and the CPU 317F-2 DP and PN/DP and the CPU
319F-3 PN/DP.
•
The
Automation System S7-400 CPU Specifications
manual describes the standard
functions of the CPU 416F-2 and CPU 416F-3 PN/DP.
•
The
ET 200S IM 151-7 CPU Interface Module
manual describes the standard IM 151-
7 CPU.
•
The
ET 200S IM 151-8 PN/DP CPU Interface Module
manual describes the standard
IM 151-7
PN/DP
CPU.
•
A separate product information bulletin is available for each applicable F-CPU. The
product information bulletins describe only the deviations from the corresponding
standard CPUs.
STEP 7
manuals
•
The
Configuring Hardware and Communication Connections with STEP 7 V5.x
manual
describes the operation of the relevant standard tools of
STEP 7
.
•
The
System Software for S7-300/400 System and Standard Functions
reference
manual describes functions for distributed I/O access and diagnostics.
STEP 7
online help
•
Describes the operation of
STEP 7
standard tools
•
Contains information about how to configure and assign parameters for modules and
intelligent slaves with
HW Config
•
Contains a description of the programming languages FBD and LAD
PCS
7 manuals
•
Describe how to operate the
PCS 7
process control system (required when ET 200S
with fail-safe modules is integrated in a higher-level control system)
The entire SIMATIC S7 documentation is available on CD-ROM.
Guide
This manual describes the fail-safe modules of the ET 200S distributed I/O system. It
consists of instructive sections and reference sections (technical specifications and
appendices).
This manual presents the following basic aspects of fail-safe modules:
●
Design and use
●
Configuration and parameter assignment
●
Addressing, assembly and wiring
●
Diagnostic evaluation
●
Technical specifications
●
Order numbers
