ET 200S Distributed I/O System - Fail-Safe Modules
Installation and Operating Manual, 08/2008, A5E00103686-07
19
Configuring
2
2.1
Configuring ET 200S with Fail-Safe Modules
Introduction
The ET 200S distributed I/O systems support configurations with standard and fail-safe
modules. This chapter presents an example configuration.
Configuration example of ET 200S with Fail-Safe Modules
In the following figure you will find a configuration example using standard and fail-safe
modules in an ET 200S. You
can divide and install the modules in fail-safe and standard
potential groups. A new potential group always begins with a power module.
30
()
(76
,0
+)
30 )', )'2 ', $2 $,
',
',
'2 '2
'2
06
30
'
'2
'2 )0
)DLOVDIHPRGXOH
7H
UP
LQ
D
WL
Q
J
P
R
G
X
OH
1
2
3
①
Fail-safe and standard potential groups mixed
②
Fail-safe potential group
③
Standard potential group
Figure 2-1
ET 200S Configuration Example with Fail-Safe Modules
WARNING
If the implemented standard module has electrical isolation of ≥ 60 VAC / 75 VDC and test
voltage of 500 VDC, it is possible to mix F-DI-/F-DO modules and standard DI-/DO-/FM
modules within one potential group as of the following MLFBs for the SIL3/Category 4/PLe:
•
6ES7138-4CF03-0AB0
•
6ES7138-4CF42-0AB0
•
3RK1903-3BA02
•
6ES7138-4FA04-0AB0
•
6ES7138-4FC01-0AB0
•
6ES7138-4FB03-0AB0
•
6ES7 138-4FR00-0AA0
For the predecessor modules, you can achieve SIL2/Category 3/PLd with a mix of F-DI-/F-
DO modules and standard DI-DO modules.
