Siemens Simatic ET 200pro FC, Operating Instructions Manual

Page: 132 / 196

Series commissioning and operation
8.1 Transfer of the frequency converter parameter assignment
ET 200pro FC
132
Operating Instructions, 07/2016, A5E01100763B AC
8.1.3 Parameter transfer with MMC
Upload from frequency converter to an MMC
The frequency converter features an MMC slot, into which a memory card can be inserted.
An upload of parameters from EEPROM to the MMC can only be triggered manually.
Prerequisites:
● The upload frequency converter's power supply must be connected.
● The upload frequency converter must be in the "Ready" state.
● You must have an MMC, type 6SL3254-0AM00-0AA0, at your disposal.
Procedure
Parameters Description (Parameter name and default setting (if this does not vary) in bold) Setting
Disassemble frequency converter, insert MMC into rear of frequency converter and re-
assemble frequency converter - Carry out the following steps in respect of the parameter set
that is to be uploaded:
P0010 = 30 Commissioning parameter*
0: Ready
1: Quick comm.
2: Frequency converter
30: Factory setting, parameter transfer
95: Commissioning of fail-safe functions
P0804 = … Select clone file
0: clone00.bin
…
99: clone99.bin
Remark: You can use P0804 to select the name of the clone file. In theory, up to a maximum of
100 (0 ... 99) parameter sets can be stored on one MMC.
P0802 = 2 Transfer data from EEPROM
0: Disabled
2: Start MMC transfer
If the upload was successfully completed, P0010 and P0802 are set to 0 and the "RY/RDY"
LED is lit.
An unsuccessful upload is signaled by an error message.