Commissioning
6.4 Restoring the factory setting
SIMATIC ET 200pro FC-2 converter
Operating Instructions, 04/2018, FW V4.7 SP10, A5E34257324B AF
77
6.4
Restoring the factory setting
When must you reset the inverter to the factory settings?
Reset the inverter to the factory settings in the following cases:
●
The line voltage was interrupted during commissioning and you were not able to complete
commissioning.
●
You can no longer trace the settings that you made during commissioning.
●
You do not know whether the inverter was already operational.
Restoring the factory settings when the safety functions are enabled
If you are using the integrated safety functions of the inverter, e.g. "Safe Torque Off", you
must reset the safety functions separately from the remaining inverter settings.
The settings of the safety functions are protected by a password.
Settings that are not changed when restoring the factory setting
The communication settings and the settings of the motor standard (IEC/NEMA) are kept
when restoring the factory setting.
6.5
Resetting the safety functions to the factory setting
Procedure
1.
Go online.
2.
Open the screen form of the safety functions.
3.
Select the button to restore the factory settings.
4.
Enter the password for the safety functions.
5.
Confirm that the parameters have been saved (RAM to ROM).
